The 36 month/36,000-mile warranty excludes failure of components due to disc thickness variation (DTV*), usually indicated by brake pulsation. ![]() Once detected, the system then is supposed to generate codes to help pinpoint the exact location of. These components can be the brake controller, trailer wiring, or the power input to the controller. If the circuit tests normal, replace the TBCM. If greater than the specified range, test the ground circuit for an open/high resistance. Test for less than 5 ohms of resistance between the ground circuit terminal 8 and ground. This warranty also excludes stripped bleeder and banjo bolt holes caused by over-tightening. This system is designed to detect problems with different components associated with your trailer brakes. Ignition OFF, disconnect the harness connector at the trailer brake controller switch panel. Failure of components due to using non-approved DOT 5 Silicone brake fluid is not covered by this warranty. ![]() ![]() Normal wear is not covered by this warranty. PowerStop LLC is not responsible for its products when they are subjected to misuse, abuse, improper application, improper installation, or accident. The product, when properly installed on the type of vehicle prescribed, and in which a defect in workmanship and material is found, will be exchanged free of charge if returned to the seller who is authorized to give this warranty. PowerStop LLC warrants this product to be free from defects and poor workmanship for 36 months from the purchase date or 36,000 miles of use, whichever occurs first.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |